Philips VR 655 - Manual (Page 4)

4
RF OUT
ANT.IN
VHF
UHF
IN OUT
AUDIO
VIDEO
L
R
G G etting C C onnected U U p
●
RF OUT
Cable
ANT. IN
RF coaxial cable
Back of TV Back of VCR
Indoor antenna
Outdoor antenna
1 1 1 Disconnect the antenna or cable from the TV.
2 2 2 Connect the antenna or cable to the ANT. IN terminal on the back of the VCR.
3 3 3 Connect the VCR to the TV using the RF coaxial cable.
4 4 4 Plug the AC power cords of the VCR and TV into the AC outlets.
If your TV has audio/video connectors, complete the connection below to get better pictures and sounds when playing back
a tape. To watch a picture from this VCR on the TV, select the AV mode on the TV.
Note;
Even if you are using this AV
connection, you must also
complete the RF connection
above.
To watch a picture from this VCR on the TV, select UHF E36 channel (video
channel of this VCR when shipped from the factory).
If you want to change video channel, see “Setting the Video Channel.” (✈P.5)
VCR to TV Connection Using AUDIO/VIDEO Cable
CAUTION
Do not plug the AC power cords
until all connections are completed.
VCR to TV Connection Using RF Cable
Note:
VR407/55 has single AUDIO IN/OUT jack.
RF OUT
ANT.IN
IN OUT
AUDIO
VIDEO
RF OUT
ANT.IN
IN OUT
AUDIO
VIDEO
L
R
Back of TV
Back of VCR
To VIDEO/
AUDIO OUT
jacks
To video and audio
input jacks
Audio cable
Video cable
VR407/55
VR607/55
Video cable
Audio cable
407/55A5 01.10.2, 8:56 AM 4