Paxar 4 - Manual (Page 29)

2. Insert the connector into the printer port until the
connector locks into place. You may hear a click as the
cable’s latch snaps into place.
3. Gently pull on the cable holder to make sure it is secure.
4. Plug the other end of the cable into the port on your host.
Removing the Communications Cable
Please follow these instructions carefully. The cable could be
damaged if removed incorrectly. To remove the cable from the
printer:
1. Hold the printer steady with one hand.
2. Grasp the cable holder with your other hand and push it in
to unlock the cable’s latch.
3. Release the cable holder and grasp the release slide.
4. Gently pull the release slide to remove the cable.
n
Do Not yank the cable from the printer.
Release
Slide
Cable
Holder
9490 Operator’s Handbook
3-2
TC9490OH Rev. C 3/97