Paxar 4 - Manual (Page 11)

Connecting the AC Power Supply –––––––––––––––––––––––––––––
c
Before you plug or unplug the power supply, turn the printer
off. Only AC power supplies approved for this printer should
be used. Using any other AC power supply may damage the
printer.
To load the AC power pack:
1. Turn the printer off. (|) indicates on and (O) indicates off.
2. Turn the printer so the back of the printer faces you.
3. Insert the tabs on the AC power pack into the slots of the
battery well in the base of the printer. Push down until the
latch clicks.
n
To remove the AC power pack, press down on the latch with
your thumb while inserting your fingers into the depression.
Lift the power pack out of the well as shown.
Latch
Tab
Finger
Depression
9490 Operator’s Handbook
1-6
TC9490OH Rev. C 3/97