Philips DCM263/55 - Manual (Page 34)

35
USB device not supported
The USB device is incompatible with the •
unit. Try another one.
Timer does not work
Set the clock correctly. •
Switch on the timer. •
Clock/timer setting erased
Power has been interrupted or the power •
cord has been disconnected.
Reset the clock/timer.
•
Moisture has condensed inside the •
system. Remove the disc and leave the
system turned on for about an hour.
Disconnect and reconnect the AC power
plug, and then turn on the system again.
As a power-saving feature, the system
•
turns off automatically 15 minutes after
disc play reaches the end and no control
is operated.
Poor radio reception
Increase the distance between the unit •
and your TV or VCR.
Fully extend the FM antenna.
•
Connect an outdoor FM antenna instead. •
Unable to select Progressive Scan
Ensure the video output mode is set to •
[Pr/Cr Pb/Cb Y].
No sound on HDMI connection.
You may not hear any sound if the •
connected device is non-HDCP
compliant or only DVI-compatible.
No picture on HDMI connection.
Check if the HDMI cable is faulty. Replace •
a new HDMI cable.
If this happens when you change the
•
HDMI video resolution, select the correct
resolution until the picture appears.
Audio or subtitle languages cannot be set
The disc is not recorded with sound or •
subtitles in multiple languages.
The audio or subtitle language setting is
•
prohibited on the disc.
Cannot display some files in USB device
The number of folders or files in the USB •
device has exceeded a certain limit. This
phenomenon is not a malfunction.
The formats of these files are not
•
supported.
English
EN