Philips DCM263/55 - Manual (Page 14)

15
Set clock
1
In the standby mode, press and hold
CLOCK on the remote control to
activate the clock setting mode.
24H begin to blink.
»
2
Press / repeatedly to toggle
between 12H and 24H.
3
Press CLOCK to confirm.
The hour digits displays and begin to
»
blink.
4
Press / to set the hour and press
CLOCK to confirm.
The minute digits displays and begin
»
to blink.
5
Press / to set the minute and press
CLOCK to confirm.
Turn on
1
Press .
The unit switches to the last selected
»
source.
4 Get started
Caution
Use of controls or adjustments or •
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from •
heat, sunshine or fire. Never discard batteries
in fire.
For first-time use:
1
Remove the protective tab to activate the
remote control battery.
2
Open the battery compartment.
3
Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
4
Close the battery compartment.
Note
Before you press any function button on the •
remote control, first select the correct source
with the remote control instead of the main
unit.
English
EN