Panasonic WV-Q151S - Manual (Page 4)

7 6
5. Mount the safety wire angle (accessory) on the 2nd anchor bolt and connect the safe-
ty wire (accessory) to the angle.
q Disconnect the safety wire from the
safety wire angle.
w Engage the face marked q with the
anchor bolt.
e Bend the face marked w.
r Connect the safety wire to the safety
wire angle again.
Note: To use the anchor bolt that was already installed, the use of 2 spacer nuts is helpful.
6. Connect the mounting base to the tip
of the safety wire.
Spacer nuts
Safety wire
Spacer nuts
Safety wire angle
Existing anchor bolt
Upper side
Lower
side
Safety wire
w Insert
q Disconnect
e Bend
Mark w
Mark q
r Connect
Safety wire angle
Anchor bolt
Safety wire (Accessory)
Mounting base
Insert the mounting
base into the hole
Roof space
3. Put Template A (accessory) against the
ceiling and make a hole.
q Make 4 holes of 12 mm {1/2"} in diam-
eter.
w Remove the center part from the tem-
plate.
e Make a hole of 160 mm {6-5/16"} in
diameter.
* The hole shape is shown below.
4. Install two anchor bolts (M10 recommended) into the concrete ceiling.
q Determine the anchor bolt length by use of Template B (accessory).
w Position the nut by use of Template B (accessory). (The distance between the bottom
surfaces of the ceiling board and nut shall be 136 mm {5-3/8"}.)
Note: If there is already an anchor bolt installed, the anchor bolt can be used as a second
anchor bolt. Make sure that the distance between the 1st and 2nd anchor bolts is 1 000
mm {39-3/8"} or less before use.
Template B
Ceiling board
Install the anchor bolt in the center of the hole
Determine the anchor bolt length
136 mm {5-3/8"}
Use a nut
Anchor bolt
ø12 mm {1/2"}
(4 positions)
Ceiling face
ø160 mm
{6-5/16"}
Template A