Philips DVDR3375/93 - Manual (Page 50)

E
n
g
lis
h
50
DVD System Menu Options
(continued)
Progressive/ Interlace
Progressive scan delivers a higher picture
quality than the standard interlaced TV
channel scan. It only works when you
have connected the DVD recorder
Y Pb Pr jacks to your TV that supports
the progressive video input. Otherwise,
the image may not appear or will be
distorted. Please check your TV user
manual for more information.
A In ‘System Menu-General’, use  keys
to select { Progressive / Interlaced }
and press OK.
{ Interlaced }
Select this to enable interlaced feature.
{ Progressive }
Select this to enable progressive scan feature.
B Use  keys to select a setting and
press OK to confirm.
Helpful Hints:
– Follow the instructions shown on the TV to
confirm the selection (if any).
– If a blank/distorted TV screen appears,
wait for 10 seconds for the auto recovery.
Video Output Format
The colour system of the DVD system,
DVD and TV should match. Only then
will it be possible to play a DVD on this
system. Before changing the TV system,
determine the colour system of your TV.
A In ‘System Menu-General’, use  keys
to select { Video Output Format } and
press OK.
{ PAL }
Select this if the connected TV has the PAL
colour system. It will change the video signal of
an NTSC disc and output it to PAL format.
{ NTSC }
Select this if the connected TV has the NTSC
colour system. It will change the video signal of
a PAL disc and output it to NTSC format.
B Use  keys to select a setting and
press OK to confirm.
Helpful Hint:
– If a blank/distorted TV screen appears,
wait for 10 seconds for the auto recovery.
Restore Factory settings
This will restore all the settings of this
DVD Recorder, except for the PIN code.
A In ‘System Menu-General’, use  keys
to select { Restore Factory Settings }
and press OK.
 A warning message will appear
B Select
OK
in the menu to proceed or
CANCEL
to abort, then press OK to
confirm.
TIPS: The underlined option is the factory default setting.
Press  to go back to previous menu item. Press SYSTEM SETUP to exit the menu item.