Philips VR200/07 - Manual (Page 9)

Initial installation
a
Open up the battery compartment of your remote control
and place the batteries in it as shown in the picture.
b Close the battery compartment.
c
Confirm the picture on the TV screen with the OK button
on the remote control.
d If you have connected the aerial to the video recorder,
press the
OK button. ’Autoinstall’ starts. This picture will
appear on the screen:
AUTOINSTALL 00
Wait until all TV channels have been found. This can take
several minutes.
e
When ’AUTOINSTALL’ is complete, ’ READY’ will appear
on the TV screen.
D If the autoinstall procedure is interrupted by the
standby button, press the MENU button to obtain the
welcome screen again.
f To end, press the MENU button.
The initial installation is now complete.
Check the time and date. Please read ’Setting the time
and date’ in this chapter.
D If you have connected a decoder, you must install it
as described in the next section.
D If you have connected a satellite receiver, please
read the section ’satellite receiver’.
Allocating a decoder
Some TV stations will send coded TV channels, that you can
only watch when you use a decoder. You can connect such a
decoder (descrambler) to your video recorder. With the
following function, the connected decoder will automatically
be activated for the TV programme you want to watch.
a Switch on the TV set. If required, select the programme
number for the video recorder.
b Choose the television channel on which you wish to use
the decoder with the
P q or P r buttons on the video
recorder or the number buttons 0-9 on the remote
control.
c
Press the MENU button on the remote control. The main
menu will appear.
d
Select the line ’ MANUAL SEARCH’ with the P q or
P r button.
e
Confirm with the OK button.
f
Press the INDEX E button. ’ DEC’ will appear in the
display.
CH21
g
Confirm with the OK button.
h To end, press the OK button again. Then, press the
TV/STANDBY m button.
This channel is now assigned to the decoder.
2. INSTALLING YOUR VIDEO RECORDER
6