Philips VR200/07 - Manual (Page 19)

D If you want to set a later end time for a recording,
press the P q button. Each time you press the
P q button, you will add 15 minutes to the end time.
f
Confirm with the OK button when the information is
correct.
D The programming information has been stored in a
TIMER block.
g
Select the recording speed SP or LP with the
SP/LP, AV button.
h
Make sure that the cassette you have put in can be
recorded on.
i
Switch off with the TV/STANDBY m button.
The programmed recording will only function when the
video recorder is switched off with the
TV/STANDBY m
button.
D If any of the TIMER blocks are in use, ’
k ’ will light up
on the video recorder display.
D While a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press the
TV/STANDBY m button.
D If the video recorder is switched on a few minutes
before a programmed recording is supposed to
begin, ’
TIMER RECORD’ will flash on the TV
screen.
D If you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
D If you forget to load a cassette, ’NO CASSETTE’
will appear on the TV screen and ’ k ’ will flash on the
video recorder display.
D If you have put in a cassette which cannot be used
for recording, the video recorder will automatically
eject it.
D If ’TIMER FULL’ appears on the TV screen when
you press the TIMER button, you have used up all
the available TIMER blocks. If you want to clear or
check a TIMER block, select it with the
P q or
P r button.
D Programme numbers ’E1’ and ’E2’ are for
recordings from other sources (through scart socket
EXT.1 AV 1 or EXT.2 AV 2 ).
Programming a recording
(without ’VIDEO Plus+’)
a Switch on the TV set and select the programme number
for the video recorder.
b Press the TIMER button on the remote control twice .
c Select a free TIMER block with the P q or P r button.
Press the TIMER button.
DATE PROG START V/P END
01 01 20:00 21:30
------------------------
NEXT
gTIMER CLEAR gCL
-/+ 0-9 D/WgSELECT OK
d
With the TIMER , C/Sq or D/Sr button you
can select ’ DATE’ (date), ’PROG’ (programme number),
’ START’ (start time) and ’END’ (end time).
Enter or change your information with the P q or
P r button, or with the number buttons 0-9 .
D Under ’DATE’, use the
SELECT button to select daily
or weekly programming.
’D’: Recording from Monday to Friday.
’W’: Recordings every week on the same day.
D Under ’START’, use the
SELECT button to switch
’VPS or PDC’ on or off.
e Confirm with the OK button when the information is
correct.
D The programming information has been stored in a
TIMER block.
f Make sure that the cassette you have put in can be
recorded on.
D Use the
SP/LP, AV button to select the recording
speed ’SP’ or ’LP’.
g
Switch off with the TV/STANDBY m button.
The programmed recording will only function when the
video recorder is switched off with the
TV/STANDBY m
button.
D If any of the TIMER blocks are in use, ’
k ’ will light up
on the video recorder display.
16