Philips VR200/07 - Manual (Page 20)

D While a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press the
TV/STANDBY m button.
D If the video recorder is switched on a few minutes
before a programmed recording is supposed to
begin, ’
TIMER RECORD’ will flash on the TV
screen.
D If you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
D If you forget to load a cassette, ’NO CASSETTE’
will appear on the TV screen and ’ k ’ will flash on the
video recorder display.
D If you have put in a cassette which cannot be used
for recording, the video recorder will automatically
eject it.
D If ’TIMER FULL’ appears on the TV screen when
you press the TIMER button, you have used up all
the available TIMER blocks. If you want to clear or
check a programmed recording (TIMER block),
select it with the
P q or P r button.
D Programme numbers ’E1’ and ’E2’ are for
recordings from other sources (through scart socket
EXT.1 AV 1 or EXT.2 AV 2 ).
How to check or change a programmed
recording (TIMER)
a Switch on the TV set and select the programme number
for the video recorder.
b Press the TIMER button on the remote control twice.
c Select the programmed recording (TIMER) you want to
check or change with the
P q or P r button.
d Press the TIMER button.
e Select the entry field with the D/Sr or C/Sq
button.
f Change any information with the P r or P q button or
with the 0-9 buttons.
g Confirm with the OK button.
h Make sure that the cassette you have put in can be
recorded on. Switch off with the
TV/STANDBY m button.
D The programmed recording will only function when
the video recorder is switched off with the
TV/STANDBY m button.
D The video recorder will always record the
programmed recording at the speed you have
selected before the recording starts.
How to clear a programmed recording
(TIMER)
a
Switch on the TV set and select the programme number
for the video recorder.
b
Press the TIMER button on the remote control twice.
c
Select the programmed recording (TIMER) you want to
clear with the
P r or P q button.
d
Press the CLEAR (CL), y button.
e Confirm with the OK button.
17