Philips VR 766/07 - Manual (Page 24)

C
OPYING
T
APE
M
ANAGER MEMORY
E
NGLISH
24 24
C Cooppyyiinngg TTaappee M Maannaaggeerr m meem moorryy
If you no longer wish to use a video recorder (henceforth
referred to as VCR A), but would still like to use your Tape
Manager archive, you can transfer the content of the memory to
a second video recorder (henceforth referred to as VCR B).
Requirement: 1. VCR B must also be equipped with a Tape
Manager System, 2. The memory of the Tape Manager of VCR B
must be empty.
1 Make sure there are no cassettes in either of
the two video recorders and switch VCR A and
VCR B off using the Standby button m m
2 Take a scart cable and connect the scart socket
A AVV11 EEX XTT11 on the back of VCR A with the scart
socket A AVV11 EEX XTT11 on the back of VCR B
3 On the front of VCR A, press simultaneously
the Record button RREEC CO ORRD D n and the
button PPRRO OG GRRA AM MM MEE --
4 On the front of VCR B press simultaneously
the Playback button PPLLA AYY G and the button
PPRRO OG GRRA AM MM MEE --
5 The data in the Tape Manager will be copied
from VCR A to VCR B. This may take several
minutes.As soon as the copying procedure has
been completed, the display will show the
message “OK”
8 8 ““NO E”” aappppeeaarrss iinn tthhee ddiissppllaayy ooff VVC CRR BB
4 4 Cassettes had already been included in the Tape
Manager of VCR B. It is not possible to perform
the copying procedure. Press the Standby button
m m to finish this function
8 8 ““NO D”” aappppeeaarrss iinn tthhee ddiissppllaayy ooff VVC CRR BB
4 4 There are no cassettes included in the Tape
Manager of VCR A. Press the Standby button m m to
finish this function
8 8 ““ERR”” aappppeeaarrss iinn tthhee ddiissppllaayy ooff VVC CRR BB
4 4 The copying procedure cannot be performed.
Perform steps 1 to 5 again
PPRRO OBBLLEEM M
6 Both video recorders switch off automaticall-
ly. The data in the Tape Manager have been
successfully transferred. Disconnect the scart
cable
h
--
PROGRAMME
VCR A
VCR B
VCR A
G
--
PROGRAMME
VCR B
AV1 EXT1