PYLE Audio 1020 - Manual (Page 8)

Pyle Pro Mixer Owner’s Manual – 13 12 – Pyle Pro Mixer Owner’s Manual
Troubleshooting
Your mixer should require very little maintenance. If you have problems, refer to the chart below
for possible solutions. If you cannot solve the problem, contact a qualified technician for assistance.
Care and Maintenance
Your Pyle Pro Mixer is an example of superior
design and craftsmanship. The following
suggestions will help you care for your mixer
so you can enjoy years of use:
• Keep the mixer dry. If it gets wet, wipe
immediately.
• Use the mixer only in well-ventilated
installations.
• Handle the mixer gently and carefully -
do not drop!
• Keep the mixer away from dust and dirt.
• Wipe occasionally with a damp cloth to
keep it looking new. Do not use harsh
chemicals, solvents or detergents!
Using the “Punch”
Controls (PYD-1015
and PYD-1020)
This featured control lets you smoothly and
quickly turn a playing source on and off, or
switch between the two different input sources
assigned to Crossfade Channel A and B.
The effect you get depends upon the position
of the Crossfader.
With the Crossfader at 100% Channel A (all
the way to the left), pressing the Channel A
Punch Button will mute the Channel A material.
Similarly, with the Crossfader at 100% Channel
B (all the way to the right), pressing the
Channel B Punch Button will mute the Channel
B material.
Punch Control
With the Crossfader in the middle position, press the Channel A punch button and the Channel A
material will be subtracted from the mix, leaving only Channel B material. Likewise, press the Channel
B punch button and the Channel B material will be subtracted from the mix.
Using the Echo Controls
(PYD-1020)
To activate the Echo mode, press the ECHO
button.
To change the number of times a sound is
repeated, increase of decrease the REPEAT
control.
To vary the time in between the repeats,
increase or decrease the DELAY control.
To adjust the output level of the echo, increase
or decrease the DEPTH control.
Echo Controls
Please
complete
warranty
card,
detach
and
return
PROBLEM POSSIBLE SOLUTION
Hum from PHONO
• Check that the turntable’s ground wire (usually black or green) is
fastened securely to the GROUND SCREW on the mixer input
panel
No signal from an
audio input
source
• Check the control setting
• Check the connection between the mixer and the input source
Nothing works • Check the AC connection. Make sure the AC outlet is “live.”
• Check the power connection to the rest of the system
(receiver/amplifier, etc.)
Hum from other
source
• Make sure there are no low level inputs connected to the LINE
input jacks
Feedback is
present
• Move the microphone further away from the output speakers,
or use a directional microphone
PYLE
PRO
Audio,
Inc.
1600
63rd
Street
Brooklyn,
NY
11204
Place Stamp
Here