Operating the synergy tru-balance power recline – Pride Mobility Mobility Power Chair User Manual
Page 9
Basic Operation Instructions
9
www.quantumrehab.com Synergy TRU-Balance Power Recline
OPERATING THE SYNERGY TRU-BALANCE POWER RECLINE
The Synergy TRU-Balance Power Recline can be operated through the PG Remote
Plus joystick, a specialty controller, the Attendant Control Module, or a toggle
(see figure 4, 5, and 6). There are inhibits on your Synergy Seating System which
will not allow you to drive your power chair or operate certain options when
reclined or elevated. See figure 2.
WARNING! Check the immediate area before operating the
recline features. Keep clear prior to and during movement.
Failure to heed can result in personal injury and/or equipment
damage.
NOTE: This manual will discuss toggle, joystick, and Attendant Control
Module operations only. If your Synergy Seating System is equipped with
a different operating device, please refer to the operation manual sup-
plied with that device and/or your power chair owner’s manual.
The Synergy TRU-Balance Power Recline is at a normal position of 95° and can
recline to 168° maximum, in infinite increments. See figure 3.
95
168
Figure 3. Angles of Recline
Recline
Lock Out
Tilt
Lock Out
Elevate
Lock Out
1/4 Speed
Full Drive
Lock Out
Elevated
x
x
Active
Tilted more than 5°
Active
Tilted more than 20°
x
Active
Reclined more than 20°
x
Active
Tilted/reclined
more than 170°
x
x
x
Active
Figure 2. Inhibit Matrix