Polaris Predator - Manual (Page 78)

75
OPERATION
Starting a Cold Engine
NOTE: The variable choke is fully on when the knob is pulled completely out. The choke
is off when the knob is pushed completely in. The choke can be adjusted gradually,
depending on how much choke is needed for starting. Be sure the choke is off during
operation, as excess fuel washing into the engine oil will increase wear on engine
components.
3. Move the engine stop switch to the RUN position. NOTE: Do not press the throttle
lever while starting the engine.
4. Turn the ignition key to the ON position and press the start button to engage the starter.
Activate the starter for a maximum of five seconds, releasing the button when the
vehicle starts. NOTE: Excessive engagement may result in starter damage.
5. If the engine does not start, wait five seconds after releasing the start button, then
activate the starter for another five seconds. Repeat until the engine starts.
6. If the engine slows or stops, position the choke knob half way in to allow proper engine
warm-up.
7. Vary the engine RPM slightly with the throttle to aid in warm-up. When the engine
idles smoothly, push the choke completely in.