Pioneer SVJ-DL01 - Manual (Page 56)

56
DJS Ver. 1.600
3
Playing Sound Using the Fader Start Functions
Contents Index
3-6-2
Cross Fader Start
How to use the Cross Fader Start function is explained here for Player
A. Before conducting the operations below, set a song for Player A
and put it into Pause (Delay) or Cue Standby mode. Move the Cross
Fader to the Player B side (i.e., to the right side).
1
Click Player A’s [Fader Start] button to display
[FS-CR].
• Every time you click the [Fader Start] button, it switches
between the modes as follows.
[FS-OFF] [FS-CH] [FS-CR] [FS-OFF]
2
Drag the slider of the [Cross Fader] toward the
Player A side (any position except the right edge).
• Once you start moving the [Cross Fader] toward the
Player A side (any position except the right edge), Player
A immediately starts playing.
Cuing Player A Back
When a cue has been set up for Player A, if you move the [Cross
Fader] to the very bottom (right edge), it returns to the cue point
set for the song on Player A and stands by at that point.
Setting a [CUE]
‘Using the [CUE] button’ P.28