Paxar Monarch DOS-based Pathfinder Ultra System 6035 - Manual (Page 96)

8-2 Defining Line Fields
Line Type Choices include segment or vector. With segments, you
choose the starting point and ending point. With vectors, you
choose the starting point, the angle, and the length of the line.
Start Row The horizontal line where printing begins.
The range is 0 – 365.
Start Column The vertical line where printing begins. The
range is 0 – 183.
End Row For segment lines only, the horizontal ending point for the
line. The range is 0 – 365. On horizontal lines, this value
must match the value for row.
End Column For segment lines only, the vertical ending point for the line.
The range is 0 – 183. On vertical lines, this value must
match the value for column.
Line Angle For vector lines only, choices include rotating the line 0, 90,
180, or 270 degrees to the left.
Line Length For vector lines only, specifies how long the line is. The
range depends on the length and/or width of your supply and
the non-print zone.
Thickness The thickness of the line. The range is 1 – 10. As thickness
increases, the line fills upward on horizontal lines or to the
right on vertical lines.