Configuring the ip network service – Polycom DOC2564A User Manual
Page 6
6
The Product Activation dialog box is displayed with the serial
number filled in.
3
In the Activation Key field, enter or paste the Product Activation Key
retrieved earlier and click OK.
If you do not have an Activation Key, click the Polycom Resource
Center button to access the Service & Support page of the Polycom
website.
The system prompts with a System Reset dialog box.
4
In the System Reset dialog box, click No.
As no Default IP Network Service is defined, the system
automatically starts the Fast Configuration Wizard.
The Fast Configuration Wizard is displayed.
Configuring the IP Network Service
The Fast Configuration Wizard enables you to configure the Default IP
Service. It starts automatically if no Default IP Network Service is defined.
This happens during First Time Power-up, before the service has been
defined or if the Default IP Service has been deleted, followed by an RMX
reset.
The IP Management Service tab in the Fast Configuration Wizard is
enabled only if the default Management IP addresses were not
modified.
1
In the Fast Configuration Wizard - IP dialog box, define the following
parameters:
On the RMX 4000, IPv4 is the default protocol for setting the Network
Service in the Fast Configuration Wizard.
Field
Description
IP Service
Name
Use the default name (Default IP Service) or enter a name
using up to 20 characters.
Note: This field is displayed in all dialog boxes.