Panasonic PT-D5500U - Manual (Page 22)

22
Projection
Powering up the projector
Remove the lens cover.
Connect the supplied power cable.
(120 V AC, 50 Hz/60 Hz)
Press the “I” marked side of the MAIN
POWER switch to turn on the power.
The power indicator lights up red, and the projector is
placed in the standby mode.
Press the “l” button. [on the main unit
or the remote control]
The power indicator illuminates in green and soon
the image is projected on the screen.
Making adjustment and
selection
Roughly adjust the focus of the lens.
(Refer to page 24.)
Press the LENS button on the main unit or the
remote control unit to display a focus adjustment
screen. Pressing
buttons to adjust the
image into focus.
Select and set the projection scheme.
(Refer to page 34.)
Select the input signal by pressing the
input selector button to toggle through
RGB1, RGB2, VIDEO, S-VIDEO and DVI.
[on the main unit or the remote control]
Turn the feet, and adjust the tilt of the
main unit in the front and rear or left
and right.
Use the lens left/right adjustment dial to
adjust the direction of the lens. (page 24)
VD SYNC/HD B/P B G/Y R R/P
SE REMOTE 1 REMOTE 2 IN IN
RGB 1 IN VIDEO IN S-VIDEO IN
IN OUT
LAMP1 LAMP2 POWER TEMP
D LP
Press the LENS button three times to
adjust the lens shift. (Refer to page 24.)
Press the AUTO SETUP button if the
input signal is RGB signal. [on the main
unit or the remote control]
Fit the image size to the screen size.
Press the LENS button twice and adjust the zoom
of the lens on the lens zoom adjustment menu.
Press the LENS button and adjust the
focus of the lens on the lens focus
adjustment menu.
Display the zoom adjustment menu
again and adjust the zoom of the lens to
fit the image size to the screen size.
(Refer to page 24.)
• If the projector is powered up at about
0˚C, a warm-up period of approximately
five minutes may be necessary to start
projection.
The temperature monitor (TEMP) lights
during the warm-up period.
When the warm-up is completed, the
temperature monitor (TEMP) turns off and
the image is projected on the screen.
• If the surrounding temperature is very low
and the warm-up period exceeds five
minutes, the control determines it as an
abnormal condition and turns off the
power automatically. If this happens, raise
the surrounding temperature to 0°C or
higher and then turn the main power “on”
and turn the power “on” (|).
Note