Paxar 611 - Manual (Page 6)

2
••
Getting Started Users Manual - 610/611/612 Printers
Audience
The Operator's Handbook is for the person who prints and applies labels.
Unpacking the Printer
After you unpack the printer, you should have: a 610 / 611 / 612 printer, power cord,
communication cable and a ribbon take-up core (may already be on take-up reel).
Keep the box and packaging material in case the printer ever needs repair.
Power cords are not supplied with 230-volt printers. You need to purchase a power cord
separately. The power cord requires IEC 320 STD C13 end finish for the printer interface
and it must meet requirements for 1.6 Amps at 115VAC and 1 Amp at 230VAC.
Connecting the Power Cable
To connect the power cable:
1. Plug the power cable into the socket.
Plug the other end of the cable into a
grounded electrical outlet.
2. Turn on the printer. Press ( I ) to turn on
and ( O ) to turn off the printer.
For information about replacing the fuse,
see Chapter 4, "Care and Maintenance."
Power Cable
goes here