Poulan 172787 - Manual (Page 14)

14
DRIVE CONTROL
FRONT WHEEL DRIVE
• Self-propelling is controlled by holding
the operator presence control bar down
to the handle and pushing the drive
control lever forward until it clicks; then
releasing the lever.
• Forward motion will stop when the op-
erator presence control bar is released.
To stop forward motion without stopping
engine, release the operator presence
control bar slightly until the drive control
disengages. Hold operator presence
control bar down against handle to con-
tinue mowing without self-propelling.
• To keep drive control engaged when
turning corners, push down on handle
and lift front wheels off ground while
turning lawn mower.
SIMPLE STEPS TO REMEMBER WHEN
CONVERTING YOUR “COMBI-CUT” OR
“MULTI-CUT” LAWN MOWER
FOR MULCHING -
• Rear mulcher plate installed and rear
door closed.
• Mulcher door closed.
FOR REAR BAGGING -
• Rear mulcher plate removed.
• Grass catcher installed.
• Mulcher door closed.
FOR SIDE DISCHARGING -
• Rear mulcher plate installed and rear
door closed.
• Discharge defl ector installed.
CAUTION: Do not run your lawn mower
without rear mulcher plate or plug in place
or approved grass catcher in place. Never
at tempt to op er ate the lawn mow er with the
rear door re moved or propped open.
GRASS CATCHER
(REAR BAGGING MODELS ONLY)
TO EMPTY GRASS CATCHER
• Simply open rear door and lift grass
catcher up and away from mower.
NOTE: Do not drag the bag when
emptying. It will cause unnecessary wear.
CAUTION: Under nor mal usage, the
catch er material is subject to de te ri o ra tion
and wear and should, therefore, be
checked frequently for replacement. Any
replacement catcher should be checked
to ensure compliance with original
man u fac tur er's spec i fi
ca tions.
CAUTION: Do not run lawn mower
with out the rear door, ap proved grass
catcher or clip ping de fl ec tor in place.
Never at tempt to op er ate mower with the
rear door removed or propped open.
OPERATOR PRESENCE CONTROL
BAR
Your lawn mower is equipped with an op-
er a tor presence control bar which re quires
the operator to be po si tioned behind the
lawn mower handle in order to start and
operate the lawn mower.
CAUTION: Federal reg u la tions require
an en gine control to be in stalled on this
lawn mower in order to min i mize the
risk of blade contact injury. Do not un der
any cir cum stanc es attempt to de feat the
func tion of the operator con trol. The blade
turns when the engine is running.
DRIVE
CONTROL
ENGANGED
Operator pres ence con trol bar
DRIVE
CONTROL
DIS EN GAGED
TO ENGAGE
DRIVE
CONTROL
Drive
control
DRIVE
CONTROL
DISENGAGED
Operator presence control bar
REAR WHEEL DRIVE (SINGLE SPEED)
• To start forward motion, lift drive control
bar up to handle.
• To stop forward motion, release drive
control bar.
REAR WHEEL DRIVE (MULTI-SPEED)
Your lawn mower provides multiple speeds to
let you select the speed that suits you best.
• Lower speeds are for slow, heavy/thick
grass cutting or trimming.
• Medium speeds are for normal grass
cutting or trimming.
• High is for light cutting and for ground
transport.
NOTE: Do not move speed control lever
unless the engine is running.