PRESTIGIO P460MW - Manual (Page 43)

43 PRESTIGIO P400MW / P460MW
ENG
Displayable Monitor
Specification
RGB Mode / HDMI Mode
Note:
a. If the set is cold, there may be a small “flicker” when
the set is switched on. This is normal, there is nothing
wrong with the set.
b. If possible, use the VESA 1,024x768@60Hz video
mode to obtain the best image quality for your LCD
monitor. If used to PC vertical frequency 85Hz, some
noise can be seen when PIP is on. In this case, set the
PC vertical fre-quency to 60Hz. The set has been pre-
adjusted to the mode VESA 1,024x768@60Hz.
c. Some dot defects may appear on the screen, like Red,
Green or Blue spots. However, this will have no impact
or effect on the monitor performance.
d. Do not press the LCD screen with your finger for a
long time as this may produce some temporary
distortion effects on the screen.
e. When the PC screen appears on the set, a message
may appear on the screen, and the message will differ
according to the Window system version (Win98,
2000). If a message appears click “Next” until the
message fin-ishes.
f. If the message “Out Of Range” appears on the screen,
adjust the PC as in the ‘Displayable Monitor
Specification’ section.
g. Supportable resolution may vary as per graphic
card.
(Synchronization input form : separate)