PRESTIGIO P460MW - Manual (Page 29)

29 PRESTIGIO P400MW / P460MW
ENG
Connection of PC
PC Setup
You can adjust horizontal/vertical position, clock, phase,
and auto-configure, reset as you prefer.
Press the MENU button and then /\ / \/ button to select the
SETUP menu.
Press the > button and then /\ / \/ button to select the
desired picture item.
Press the < / > button to make appropriate adjustments.
H-Position / V-Position
This function is to adjust picture to left/right
and up/down as you prefer.
Clock
This function is to minimize any vertical bars or
stripes vis-ible on the screen background. And
the horizontal screen size will also change.
Phase
This function allows you to remove any horizontal noise and clear or sharpen the image of characters.
Auto-configure
This function is for the automatic adjustment of the screen position, clock and phase. The displayed image will disap-pear
for a few seconds while the Auto-configuration is in progress.
Reset
This function allows you to return to the good picture repro-duction programmed at the factory and cannot be changed.
Note : Some signal from some graphics boards may not function properly. If the results are
unsatisfactory, adjust your monitor’s position, clock and phase manually.
Press the OK button to store it for the PC monitor picture.
Press the EXIT button to return to PC mode.
WXGA (or VGA (Only RGB
mode))
a : When the set is inputted WXGA signal, select
the desired WXGA resolution.
b : When the set is inputted HDMI-480p signal
in VGA mode, select 480p on the SETUP menu.