Panasonic TQBJ0303-1 - Manual (Page 22)

Switching the projector on/off
22 -
E
NGLISH
Basic Operation
Switching off the projector
When operating the projector, check the status of the POWER indicator. ( Æ page 20)
INPUT SELECT
RELEASE
POWER indicator
POWER LOCK indicator
(1), (2)
Press the POWER button. 1 )
The confirmation screen will be displayed.
Without any operation for 10 seconds or press any button other than the z POWER button, the confirmation
screen will go off and return to the projection.
Press the POWER button again. 2 )
The lamp goes off, the operational sound (beep) sounds, and projection stops.
The cooling fan continues its rotation and z POWER indicator lights in orange. Wait until the POWER LOCK
indicator and POWER indicator turn into red.
If z STANDBY MODE is set to NORMAL, the POWER indicator flashes in red. ( Æ page 40)
You can set to z ON or OFF the beeping sound that occurs when the POWER button is in operation in
AUDIO SETTING.
( Æ page 41)
After the POWER LOCK indicator and POWER indicator light in red, disconnect the 3 )
mains plug from the mains socket. ( Æ page 19)
For urgency, you may disconnect the mains plug immediately since the z DIRECT POWER OFF function is
installed.
Remarks
Confirm that z CONTROL PANEL (when operating with the projector body) or REMOTE CONTROLLER (when
operating with the remote control) under CONTROL DEVICE SETUP in the SECURITY menu is set to ENABLE.
( Æ page 44)
You can switch off the power by pressing the z POWER button for 0.5 seconds or more.