Philips 55PP9401 - Manual (Page 2)

2
H
OOKING
U
P
Y
OUR
TV (B
ASIC
TV C
ONNECTIONS
)
B ASIC VCR H OOKUP
Connect your antenna or
cable TV signal to a two-way signal
splitter.
Connect one end of coaxial
cable to each of the output plugs on
the signal splitter.
Connect one of the signal
splitter outputs to the ANT(enna)
IN(put) on the VCR.
Connect the remaining signal
splitter output to the ANT(enna) A
input on the back of the TV.
Connect either the S-VIDEO or
V(ideo) output jack and the L(eft) and
R(ight) audio output jacks on the back
of the VCR to the matching AV 1 jacks
on the back of the TV.
Connect the INPUT jack on
the back of the cable box to the TO
CONVERTER jack on the back of the
TV. Then connect the OUTPUT jack on
the back of the cable box to the
ANT(enna) B input on the back of the
TV.
F ollow the steps to the right
to connect a basic antenna
or cable TV signal to a VCR,
and then the VCR to the TV.
Refer to the owner’s manuals
for your VCR and cable con-
verter box for further informa-
tion on hookups.
F RONT P ANEL J ACKS
✔ Be sure to com-
pletely insert cord
plugs when connect-
ing to the Front
Panel jacks. If you
don’t, the played-
back picture may be
abnormal.
✔ If you have an
S-VHS VCR, use
the S-INPUT cable
in place of the stan-
dard video cable.
✔
If you have a
mono VCR, insert
the audio cable into
the left audio jack of
your TV.
CHECK IT OUT
OUTPUT
V L R S-VHS
AUDIO
S-VIDEO VIDEO L/MONO R
1
TV's Front Jack Panel
Back of VCR
AUDIO
S-VIDEO VIDEO L/MONO R
2
TV's Front Jack Panel
Camcorder
VCR
OR
T he Front Panel jacks offer
you the convenience of easy
connection to a camcorder or
VCR.
Connect the S-VHS or Video
OUTPUT jack and the audio L(eft)
and R(ight) OUTPUT jacks on the
back of the VCR to the TV’s Front
Panel jacks.
Connect the S-VHS and audio
L(eft) and R(ight) OUTPUT jacks on
the camcorder to the TV’s Front Panel
jacks.
✔ Your TV remote
control allows you
to switch between
two separate
75-ohm antenna
inputs, ANT(enna)
A and ANT(enna) B.
You can display the
ANT(enna) A input
as a main picture or
subpicture (Picture-
in-Picture). You can
display ANT(enna)
B only as a main
picture. (ANT[enna]
B cannot be dis-
played as a subpic-
ture.) The antenna
output labeled “TO
CONVERTER”
allows the
ANT(enna) A con-
nection to pass
directly to a differ-
ent source such as a
cable box, only
when ANT(enna) B
is displayed as a
main picture.
CHECK IT OUT
Connect either the S-VIDEO
or the VIDEO Jacks.