Polaroid Polaview 110 - Manual (Page 7)

Also included but • 2 AA alkaline batteries
not shown
• European power cord
• User’s guide
• U.K. power cord
• Product registration card
Quick start
Place the Model 110 projector on a solid flat surface at a
right angle (perpendicular) to the projection screen, parallel
to the floor. Follow the appropriate section below for the
type of system that you have. These steps are described in
Chapter 2, Detailed setup.
Note: The projector has two sets of computer video and
audio inputs. The following examples describe the use of
input 1.
Desktop PCs
1 Unplug the monitor cable from the computer.
2 Plug one end of the supplied VGA cable into the RGB 1 IN
port on the projector. Plug the other end into the computer
Monitor Out port.
3 Connect your audio source to the AUDIO 1 IN port on the
p r o j e c t o r .
4 You can project without using the PC monitor. To use the
monitor, plug the monitor cable into the RGB OUT port on
the projector.
5 Turn the projector on and press the STANDBY/ON key.
Desktop Macintosh computers
1 Unplug the monitor cable from the computer.
2 Plug one end of the supplied VGA video cable into the RGB
IN 1 port on the projector. Attach the VGA end of the Mac -
VGA cable adapter to the other end of the VGA video cable.
Introduction 3