Philips DCR5012 User Manual
Page 9
Getting started
69
Check the smart card
Check whether the UPC smart card is inside the
front slot of the Digital Cable Receiver.
If this is not the case, slide it in the slot:
Open the smart card door on the right
•
side of the box.
Insert the smart card into the smart card slot
•
as far as it will go. The end of the card will be
visible from outside the slot.
Warning
Insert the smart card with the chip facing down.
4.2 Connect
Danger
Risk of electric shock!
Make sure all the devices are disconnected from
the mains before making any connections.
HDMI connection
Connect the coaxial cable from the cable
wall socket to the RF IN socket at the rear
of the Digital Cable Receiver.
Connect the HDMI cable to the HDMI input
of the TV set and to the HDMI socket at
the rear of the Digital Cable Receiver.
Plug your Digital Cable Receiver to the
mains using the supplied power cord. The
front display panel indicates Init, then UPC.
Note
For scart connection, refer to chapter 7.2.
4.3 Install
Before you start installation, make sure you have
made all the required connections.
Switch on your TV set. The country selection
screen appears. In that case, the Digital
Cable Receiver has automatically started up
at connecting.
Note
If you can’t you see the country selection screen,
switch on the Digital Cable Receiver by pressing
at the front of the Digital Cable Receiver or
press the remote control. In case you still can’t
see this screen, check whether your TV is set to
the right A/V (Audio/Video) channel.
Read the manual of your TV set if you do not
know how to set the A/V channel. In case you
still can’t see the screen, check all connections
and start installation again. If everything is
properly connected and you still can’t see the
country selection screen, after multiple efforts,
please contact UPC Customer service.
Warning
Do not switch off the Digital Cable Receiver
during activation.
Also pay special attention to children, so that
they cannot interrupt activation, for example by
pulling the plug from the socket of by pressing
on it.
Digital Cable Receiver
Cable Wall
Socket
TV set