Philips DCR5012 User Manual

Page 34

Accessories and connections

ENGLISH

Connections

8.2

Scart connection

Connect the supplied coaxial cable from the

cable wall socket to the RF IN socket at the
rear of the Digital Cable Receiver.

Connect a scart cable to the scart input of

the TV set and to the TV scart socket at the
rear of the Digital Cable Receiver.

Connect a coaxial cable to the RF input at

the rear of the TV set and to the RF OUT
socket at the rear of the Digital Cable
Receiver.

Plug your Digital Cable Receiver to the

mains using the supplied power cord.

Warning

The image quality will not be in High Defi nition
with the scart connection.

• Press the UPC key immediately after your
television switches off to store the setup code.

Note

You may have to press CH+ several times
before the correct setup code is found and your
television switches off. It may take around 15
minutes to fi nd the code using the Search for
setup code function. When searching for the
setup code, make sure you keep the remote
control pointed at the television.

Replacing the batteries
The remote control is supplied with two new
alkaline batteries (type AAA/LR03). If the remote
control is not working, or no longer works
properly, you probably need to replace the
batteries:
• Open the cover on the back of the remote
control.
• Insert two new batteries and close the cover
to the battery compartment

Please note:
Never mix old and new batteries or different
types of batteries (standard and alkaline).

Tip

You can also switch the Digital Cable Receiver
on and to standby and change the channels
without the remote control.
Switch on the Digital Cable Receiver by pressing
CH+ on the front of the media box.
Once the Digital Cable Receiver is switched on,
you can change channels by pressing CH+/- on
the front of the media box. Press to switch
the Digital Cable Receiver to standby.

Digital Cable Receiver

TV set

Cable Wall
Socket