Panasonic AJ-LT85P - Manual (Page 30)

30
V V
T T
R R
1 2
TIME CODE
Item Setting
Description of setting
No. Item No. Item
500 VITC 0000 10L
POS-1
0006 16L
™ ™
0010 20L
501 VITC 0000 10L
POS-2
0008 18L ™ ™
0010 20L
502 VITC 0000 BLANK
BLANK 0001 THRU
™ ™
503 TCG 0000 TC&UB
REGEN 0001 TC
0002 UB
™ ™
504 BINARY 0000 000
GP 0001 001
0002 010
0003 011
0004 100
0005 101 ™ ™
0006 110
0007 111
505 TCG CF 0000 OFF
FLAG 0001 ON
™ ™
506 DF MODE 0000 DF
0001 NDF
™ ™
The underlined number and item are the factory settings.
DETAILED DESCRIPTION OF SET-UP MENUS
This sets the position where the VITC signal is to be inserted. (The same line
as that selected for 501:VITC POS-2 cannot be selected.)
This sets the position where the VITC signal is to be inserted. (The same line
as that selected for 500:VITC POS-1 cannot be selected.)
This sets whether the VITC data is to be output to the position which has
been selected by 500:VITC POS-1 and 501:VITC POS-2.
0: VITC data is not output.
1: VITC data is output.
This selects the signal to be regenerated when the TCG is in the REGEN
mode.
0: Both the time code and user bit are regenerated.
1: Only the time code is regenerated.
2: Only the user bit is regenerated.
This sets the status for using the user bit of the time code generated by the
TCG.
0: NOT SPECIFIED (character set is not used)
1: ISO CHARACTER (8-bit character set complying with ISO646 and
ISO2022 is used)
2: UNASSIGNED-1 (not defined)
3: UNASSIGNED-2 (not defined)
4: UNASSIGNED-3 (not defined)
5: PAE/LINE (SMPTE262M page/line multiplexing system)
6: UNASSIGNED-4 (not defined)
7: UNASSIGNED-5 (not defined)
This selects whether the CF flag of the TCG is to be used.
0: CF flag is not used.
1: CF flag is used.
This selects the drop frame or non-drop frame mode for CTL and
TCG.
0: For establishing the drop frame mode.
1: For establishing the non-drop frame mode.