Polaris Outlaw - Manual (Page 78)

75
OPERATION
Starting a Cold Engine
3. Sit on the ATV. Pull the choke knob (1) out until it stops.
NOTE: If the knob doesn’t stay where positioned,
increase the tension by rotating the tension
adjusting nut clockwise.
FULL ON
HALF ON
OFF
NOTE: The choke can be adjusted gradually, depending on how much choke is needed
for starting. Be sure the choke is off during operation, as excess fuel washing into
the engine oil will increase wear on engine components.
4. Move the engine stop switch to RUN.
5. Turn the ignition key to ON.
1