Polaris Outlaw - Manual (Page 158)

155
ADJUSTMENTS
Front Suspension
Suspension Set-Up
6. Place the transmission in neutral and slowly roll the machine forward and rearward at
least ten feet (3 m) without lifting or pushing down on the suspension.
7. Turn the handlebars fully to the left and right.
8. With the rider still on the vehicle, repeat the measurement performed in step 4.
9. Subtract the step 8 measurement from the step 4 measurement. The difference should
be between 3.75 and 4 inches (9.5-10.2 cm).
10. If the number is less than 3.75 inches (9.5 cm), decrease the front spring preload (see
page 157) and repeat all steps. If the number is higher than 4 inches (10.2 cm), increase
spring preload and repeat all steps.