Pioneer AVH-P4200DVD - Manual (Page 77)

iPod
Message Cause Action
Format Read/
Ready Sometimes there
is a delay be-
tween the start of
playback and
when you start to
hear any sound. Wait until the mes-
sage disappears
and you hear
sound.
Error-02-6X/-
9X/-DX Communication
failed. Disconnect the
cable from the
iPod. Once the
iPod's main menu
is displayed, recon-
nect the iPod and
reset it.
iPod failure Disconnect the
cable from the
iPod. Once the
iPod's main menu
is displayed, recon-
nect the iPod and
reset it.
Error-02-67 The iPod firm-
ware versions are
old. Update the iPod
version.
Stop There are no
songs. Transfer songs to
the iPod.
There are no
songs in the cur-
rent list. Select a list that
contains songs.
iTunes tagging
Message Cause Action
iPod full. Tags
not trans-
ferred. Memory used for
tag information
on the iPod is
full. Sync the iPod with
iTunes and clean
up the tagged play-
list.
Memory full.
Tags not
stored. This unit
’s flash
memory used as
the temporary
storage area is
full.
Connect the iPod
to this unit and
transfer this unit
’s
tag information to
the iPod.
Tags trans-
ferred failed. This unit
’s tag in-
formation cannot
transfer to the
iPod.
Check the iPod
and try again.
Tag store
failed. Tag information
cannot be stored
in this unit. Try again.
Message Cause Action
Error-8D Built-in FLASH
ROM encoun-
tered an error Turn the ignition
OFF and ON.
SD source can-
not be se-
lected during
tag transfer. Tag information
is being trans-
ferred to the
iPod. Wait until tag
transfer is com-
plete.
Bluetooth
Message Cause Action
Error-10 The power failed
for the Bluetooth
module of this
unit. Turn the ignition
switch OFF and
then to ACC or ON.
If the error mes-
sage is still dis-
played after
performing the
above action,
please contact
your dealer or an
authorized Pioneer
Service Station.
Understanding auto EQ
error messages
When correct measurement of the car
’s inter-
ior acoustic characteristics is not possible
using auto EQ, an error message may appear
on the display. In such cases, refer to the table
below to see what the problem is and how it
may be corrected. After checking, try again.
Message Cause Action
Error. Please
check MIC. The microphone
is not connected. Plug the optional
microphone se-
curely into the
jack.
En
77
Appendix
Additional
Information
Additional Information