Patton electronic 2616RC User Manual
User manual
Table of contents
Document Outline
- Summary Table of Contents
- Contents
- List of Figures
- List of Tables
- About this guide
- Chapter 1 Introduction
- Chapter 2 Hardware installation
- Introduction
- Unpacking the Model 2616RC T-DAC
- T-DAC blades installation
- Cable installation
- Connecting the Ethernet ports
- Connecting the 10/100Base-T Ethernet port to an Ethernet-capable workstation or PC
- Connecting the EIA-561 RS-232 configuration port (DCE configured)
- Connecting the T1/E1 WAN ports
- Installing the WAN cable to a punch-down block
- 68-pin SCSI to open end, 6 foot cable (part #10-3096TM68-6)-Obsolete
- 68-pin SCSI to 64-pin female Telco (part #10-3096TM68/64-6)
- Completing the hardware installation
- Chapter 3 Configuring the T-DAC for operation
- Introduction
- Configuration prerequisites
- Initial configuration through the RS-232 control port
- Using a browser to complete Model 2616RC configuration
- Displaying the T-DAC 2616RC web administration pages
- Configuring the default gateway
- Configuring the system clocking parameters
- Configuring the DS0 mapping
- Configuring line settings and signaling for E1
- Configuring the E1 line interface settings
- Configuring line settings and signaling for T1
- Enabling/disabling the alarm card
- Saving your configuration
- Backing up your configuration parameters
- Completing the installation
- Chapter 4 Operation and shutdown
- Chapter 5 Troubleshooting and maintenance
- Chapter 6 Contacting Patton for assistance
- Appendix A Compliance information
- Appendix B 68-pin SCSI-to-open-end 6-foot cable (part #10-3096TM68-6)