Pioneer PDP-5030HD - Manual (Page 70)

E-67
HOW TO SET THE FACTORY PRESETTINGS
Press and hold down CLEAR on the Media Receiver while it is in standby mode. Then press STANDBY/ON
on the Plasma Display or TV a on the remote control unit to turn the Plasma Display System on.
All setting items (except TV channel) return to the factory presetting.
A
• Running the factory presetting operation also clears the secret number.
You can run the Auto Installation again by using the following steps.
1
Turn on the power of the Plasma Display and the Media Receiver.
2
Press MENU. (Make sure the menu screen displays.)
3
Press a/b to select “Setup”.
4
Press SET/ENTER.
A
• If the secret number setting screen displays, you need to enter your secret number.
• If you forget your secret number, refer to HOW TO SET THE FACTORY PRESETTINGS above.
5
Press a/b to select “Auto Installation”.
6
Press SET/ENTER.
“Auto Installation completed” displays. After that, the screen changes to the TV mode.
* 1 SRS and the symbol are trademarks of SRS Labs, Inc.
SRS technology is incorporated under license from SRS Labs, Inc.
* 1 FOCUS and the symbol are trademarks of SRS Labs, Inc.
FOCUS technology is incorporated under license from SRS Labs, Inc.
A
• Products above are a trademark or registered trademark of corporation.
A
• As a precautionary measure, make a note of your secret number above, scissor it from this manual, and keep it in a
familiar place.
The secret number is .