Pioneer PDP-5030HD - Manual (Page 67)

E-64
Appendix
• No power.
• Unit cannot be operated.
• Remote control unit does not
operate.
• Picture is cut off/with sidebar
screen.
• Strange color, light color, dark or
color misalignment.
• Power is suddenly turned off.
• No picture.
Problem Possible Solution
• Make sure the Plasma Display and the Media Receiver are connected correctly.
(See page 6.)
• Check if you pressed TV a on the remote control unit. (See page 14.)
If the indicator on the Plasma Display lights up red, press TV a.
• Is the power cord disconnected? (See page 13.)
• Has the main power been turned on? (See page 14.)
• External influences such as lightning, static electricity, may cause improper
operation. In this case, operate the unit after first turning on the power of the
Plasma Display and the Media Receiver, or unplugging the power cord and
replugging it in after 1 or 2 minutes.
• Is the Mode switch set correctly? Slide it to the TV setting position.
• Are batteries inserted with polarity (e, f) aligned? (See page 8.)
• Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fluorescent lighting?
• Is a fluorescent light illuminated near the remote control sensor?
• Is the image position correct? (See pages 22 and 41.)
• Are screen mode adjustments such as picture size made correctly? (See page
45.)
• Adjust the picture tone. (See pages 27 to 30.)
• Is the room too bright? The picture may look dark in a room that is too bright.
• Check the input signal setting. (See page 43.)
• Is the sleep timer set? (See page 46.)
• Check the power control setting. (See pages 32 and 33.)
• The unit’s internal temperature has increased.
Remove any objects blocking vent or clean. (See page 5.)
• Is connection to other components correct? (See pages 34 to 39.)
• Has setup been done correctly after connection? (See page 43.)
• Is the correct input selected? (See page 43.)
• Is a non-compatible signal being input? (See page 65.)
• Is picture adjustment correct? (See pages 27 to 30.)
Problem with Plasma Display System Warning Possible Solution
• System cable connection
• Abnormal internal temperature
• Abnormal internal signaling or circuit
operation of the Plasma Display
• System cables are not properly connected. Check that
all system cables are connected properly. (See page
6.)
• The internal temperature of the Plasma Display is
abnormally high. Check the location the System is
installed. (See page 5.)
• Turn off the power once and turn it on again. (See page
14.)
E01
E04
E06
Please check to see if a warning is displayed on the screen. If the problem still cannot be solved please consult the dealer
where this unit was purchased.
Troubleshooting