Pioneer PDP-5030HD - Manual (Page 42)

E-39
Using external equipment
POWER
STANDBY/ON
MEDIA RECEIVER PDP-R03U
RGB cable
(commercially available)
Media Receiver (front view)
ø 3.5 mm stereo minijack cable
(commercially available)
Computer
15 14 13 12
9
11
10 8 7 6
5 4 3 2 1
INPUT SOURCE
TV
INPUT1
INPUT2
INPUT3
INPUT4
PC
Pin No. Signal name Pin No. Signal name Pin No. Signal name
1 R 6 GND (Ground) q Not connected
2 G 7 GND (Ground) w SDA
3 B 8 GND (Ground) e HD
4 Not connected 9 ם5V r VD
5 CSYNC 0 GND (Ground) t SCL
Viewing an image from a computer
Connecting a computer
Use the PC terminals to connect a computer.
A
• The PC input terminals are DDC1/2B-compatible.
• Refer to page 65 for a list of computer signals compatible with the Plasma Display System.
Signal names for 15-pin mini D-sub connecter
A
• Macintosh adaptor may be required for use for some Macintosh computers.
Displaying an image from a computer
When connecting to a computer, the correct input
signal type is automatically detected. If the computer
image does not come in clearly, you may need to set
the Auto Sync. adjustment on the “Auto Sync.” in the
menu. (See page 42.)
You only need to select the input source on the “INPUT
SOURCE” menu.
To view an image from a computer, select “PC” from
the “INPUT SOURCE” menu using INPUT on the
remote control unit or on the Plasma Display. (See page
43.)
A
• Each time INPUT is pressed, the input source toggles.
• PC INPUT terminals cannot be used for audiovisual
equipment. Use the INPUT 3 (RGB) terminal on the rear
of the Media Receiver when connecting audiovisual
equipment with an RGB signal.(See page 37.)
TV
ANT INPUT
SURR
FRONT
AV
SELECTION
MTS CC
SPLIT SELECT
SUB SUB CH
؀
FREEZE MODE
SCREEN
SLEEP LEARN EDIT/ DISPLAY
INPUT ؁
TV VCR CBL
/SAT
/DTV
DVD
/LD
1 2 3
4 5 6
7 8 9
0 CH
ENTER