Panasonic VW-BN1 - Manual (Page 7)

7
LSQT1268 (ENG)
≥ Discs recorded on this unit may not
be playable on other products. In
such cases, play back the disc on this
unit instead.
≥ When using DVD-RW, DVD-R or
DVD-R DL do not perform the
following as it may make the disc
unusable.
– Record on a disc with other products
after recording on it with this unit.
– Record on a disc with this unit after
recording on it with other products.
– Insert an un-finalized disc in any other
products.
∫ About DVD-R DL
(dual layer on single side)
DVD-R DL (dual layer on single side) discs
have two layers of recording and playback
surface on one side. If a scene does not fit
on the first layer (L0), recording continues
on the second layer (L1) so one scene is
recorded across two layers. This unit
automatically switches layers during disc
playback so you can play the whole disc
continuously like a normal disc. However,
the image or the sound may momentarily
stop at the point where the layers switch.
∫ Examples of discs that cannot be
used on this unit
∫ How to hold a disc
Do not touch the recorded surface.
∫ When inserting/removing a disc
Do not allow fingerprints or dirt to get on
the recording/playback side of the disc.
≥ If there are scratches or dirt (e.g. dust or
fingerprints) on the recording/playback
side of the disc, normal recording/
playback may not be possible and the
following may occur:
– Recording/playback is not possible.
– The image or the sound is interrupted
or stops momentarily.
– Noise may appear on the image and/or
the sound.
∫ If there is dirt on the disc
≥ Clean it with the commercially available
disc cleaning cloth. Wipe the disc from
the center to the outer edge to remove
the dirt. Do not use force when wiping
the disc as it may scratch it. Also, do not
use solvents (thinner, water, antistatic
agent, detergent etc.).
∫ Handling precautions
≥ Be careful about scratches and dirt.
≥ Do not attach labels or stickers to discs.
(This may cause disc warping and
un-balanced rotation, rendering it
unusable.)
≥ Write on the label side of the disc only
with a soft, oil-based felt pen. Do not use
ballpoint pens or other hard writing
implements.
≥ Do not use record cleaning sprays,
benzine, thinner, static electricity
prevention liquids or any other solvent.
≥ Do not use scratch-proof protectors or
covers.
≥ Do not drop, stack, or impact discs. Do
not place objects on them.
≥ Do not use the following discs:
– Discs with exposed adhesive from
removed stickers or labels.
≥ Discs other than those with a 12 cm (5z)
diameter (You cannot use 8 cm (3z) discs
even if you insert them in a commercially
available adaptor.)
≥ 6X–12X high speed recording compatible
DVD-RAM
≥ iRW ≥ iR ≥ iR DL
≥ BD-RE ≥ BD-R ≥ BD-ROM
≥ HD DVD-RAM ≥ HD DVD-RW≥ HD DVD-R
≥ LD ≥ MO ≥ MD
≥ iD ≥ Floppy disk
LSQT1268_Eng.book 7 ページ ２００７年７月２３日 月曜日 午後３時４４分