Philips 14PV340 - Manual (Page 7)

Initial installation
a Open up the battery compartment of your remote control
and place the batteries in it as shown in the picture.
b Close the battery compartment.
c Select the language for the on-screen display (OSD) with
the
P rB or AP q button.
d Confirm with the OK button.
e Select the country of your residence with the P rB or
AP q button.
If this country does not show up, select ’ OTHER ’.
f Confirm with the OK button.
g If the aerial (antenna) has been connected to the
TV-VIDEO Combi and the radio aerial has been adjusted,
press the
OK button.
’Automatic TV channel search’ starts. This picture will
appear on the screen:
Searching ...
CHANNELS FOUND: 06
Radio channels stored: 7
//////,,,,,,,,,,,,,,,,,,,,,
Wait until all TV channels have been found. This can take
several minutes.
E ’
Time ’, ’ Year ’, ’ Month ’ and ’ Date ’ will appear on
the TV screen.
Autostore ready
CHANNELS FOUND: 09
Radio channels stored: 2
Time 15:36
Year 1999
Month 01
Date 01
Exit:
press MENU
h Check if the time in line ’ Time ’ is correct. If required,
change the time with the number buttons 0-9 on your
remote control.
i Check ’ Year ’, ’ Month ’ and ’ Date ’ in the same way.
You can switch between lines with P rB or AP q
button. Confirm the new information with the OK button.
The initial installation is now complete.
D If you have connected a decoder, you must install it
as described in the next section.
D If you have connected a satellite receiver, please
read the section ’satellite receiver’.
2. INSTALLING YOUR TV-VIDEO COMBI
5