Panasonic CF-VDM292U - Manual (Page 8)

8
E
Using the Drive
Center Holder
Eject Button
Label side up
1
Power on your computer.
2
Open the disc tray.
Press the eject button and slowly pull out the tray.
3
Place a disc.
Place the disc with the label facing upward in
the drive.
Push down until the center holder clicks.
Place a finger on the center holder and lift up on the
edge of the disc.
4
Close the disc tray.
Close the tray without touching the eject button.
If the drive has not been accessed within 30 seconds, the drive motor will automatically shut
down to reduce the power consumption. When the drive is accessed once again, the power
of the drive motor is turned on. However, approximately 30 seconds are required until data
is actually read from the disc.
Power-saving Mode
Setting a Disc
After the tray closes, do not access the drive until the multimedia pocket device
status indicator
goes off.
If the vibration of the drive is excessive, check to see if the disc is inserted correctly,
and check that the disc is in good condition. If the disc is good and inserted correctly,
set [CD/DVD Drive Speed] or [CD Drive Speed] to [Low] in the Setup Utility. (This
setting does not work for the DVD disc when using CF-29C****** and CF-
29D****** model.)
CAUTION