Installing the unit, Overview, Package checklist for hotwire model 7924-a1 – Paradyne 7924 User Manual
Page 15: Chapter 2
2-1
7924-A2-GB20-30
October 1997
Installing the Unit
2
Overview
This chapter describes the procedure for installing a single standalone
termination unit using a 120 Vac or 230 Vac power supply (Model 7924-A1-20x or
7924-A1-30x).
If you have multiple standalone units at the same location, you may want to
consider installing the units in a HotWire Model 7900 10-Slot Standalone Shelf.
The Standalone Shelf is a convenient method for housing up to ten standalone
termination units and uses only a single power source.
HotWire Model 7924-A1-50x units (which use – 48 Vdc direct power) must be
installed in a HotWire 7900 10-Slot Standalone Shelf. Installation instructions for
these models are not provided in this User’s Guide.
To obtain information on the Standalone Shelf, refer to
Package Checklist for HotWire Model 7924-A1
Verify that your package contains the following:
-
HotWire Model 7924-A1 unit
-
VT100 Terminal Cable
-
14
′
twisted-pair network cable
-
Power cord with power transformer (optional)
-
Warranty card