Protec Protech Compact2 Film Processor SX 2 - Manual (Page 20)

20 COMPACT 2 TM
Care
®
Care
Daily Care
Before use...
1.
Remove dirt and dust from film-infeed with soft cloth.
2. Run 2 - 3 cleaner films through processor to remove all accumulated dirt and
dust from the rollers.
3. Check the liquid level in the replenishment containers and if necessary refill.
After use...
•
When working has been completed at the end of the day, the water must be
drained out of the machine. This reduces the growth of algae in the water
bath. For that purpose open the water drainage stop cock (see
page 7 bot-
tom).
Weekly Care
The developer chemicals cause residue build-up in the machine. This residue has
a negative effect on the developing process of the film material. For this reason the
processor has to be regularly cleaned of this residue.
Do a weekly clean of the roller racks, which only takes a few minutes.
1. Switch machine off and remove cover.
2. Loosen the securing latches (red, blue and beige) of the drive shafts of each
roller rack at the right side.
3. Rinse all racks thoroughly under warm running water and then leave to drain
off. Use a soft sponge (do not use scouring-pad, as this would scratch the roll-
ers!) and remove the pollution from the rollers. During this procedure, the roll-
ers can be turned by turning the drive shaft.
4. Wipe the infeed-roller-pair (first roller-pair of developer rack) dry.
5. Replace the racks: Red = Developer, Blue = Fixer. Beige = Washing/Drying.
Ensure that the racks are firmly installed and do not forget to close the secur-
ing latches on the drive shafts.
6. Replace machine cover and ensure it is securely closed.
7. Clean processor outer casing with damp cloth. Do not use aggressive clean-
ers or solvents.
Attention:Do not let any liquid drop inside the processor or
run over the control.Liquids may cause damage to the proces-
sor.
Please note:
When removing the Rinsing / Drying roller-rack, ensure that no
water gets into the film dryer air channel.