Available accessories – Pioneer AVH-P3100DVD User Manual

Page 91

The auto-equalizer automatically measures
the car interior acoustic characteristics, and
then creates the auto-equalizer curve based
on that information.

WARNING

To prevent accidents, never carry out auto TA and
EQ while driving. When this function measures
the car interior acoustic characteristics to create
an auto-equalizer curve, a loud measurement
tone (noise) may be outputted from the speakers.

CAUTION

! Carrying out auto TA and EQ under the follow-

ing conditions may damage the speakers. Be
sure to check the conditions thoroughly be-
fore carrying out auto TA and EQ.
— When speakers are incorrectly connected.

(e.g., When a rear speaker is connected to
a subwoofer output.)

— When a speaker is connected to a power

amp delivering output higher than the
speaker

’s maximum input power capabil-

ity.

! If the microphone is placed in an unsuitable

position the measurement tone may become
loud and measurement may take a long time,
resulting in a drain on battery power. Be sure
to place the microphone in the specified loca-
tion.

Before operating the auto TA and EQ
function

! Carry out auto TA and EQ in as quiet a

place as possible, with the car engine and
air conditioning switched off. Also cut
power to car phones or portable telephones
in the car, or remove them from the car be-
fore carrying out auto TA and EQ. Sounds
other than the measurement tone (sur-
rounding sounds, engine sound, tele-
phones ringing etc.) may prevent correct
measurement of the car interior acoustic
characteristics.

! Be sure to carry out auto TA and EQ using

the supplied microphone. Using another
microphone may prevent measurement, or
result in incorrect measurement of the car
interior acoustic characteristics.

! When front speaker is not connected, auto

TA and EQ cannot be carried out.

! When this unit is connected to a power

amp with input level control, auto TA and
EQ may not be possible if you lower power
amp input level. Set the power amp

’s input

level to the standard position.

! When this unit is connected to a power

amp with an LPF, turn off the LPF on the
power amp before carrying out auto TA and
EQ. In addition, the cut-off frequency for
built-in LPF of an active subwoofer should
be set to the highest frequency.

! The time alignment value calculated by

auto TA and EQ may differ from the actual
distance in the following circumstances.
However, the distance has been calculated
by computer to be the optimum delay to
give accurate results for the circum-
stances, so please continue to use this
value.
— When the reflected sound within a vehi-

cle is strong and delays occur.

— When delays occur for low sounds due

to the influence of the LPF on active
subwoofers or external amps.

! Auto TA and EQ changes the audio settings

as below:
— The fader/balance settings return to the

center position. (Refer to page 84.)

— The equalizer curve switches to Flat.

(Refer to page 89.)

— It will be adjusted automatically to high

pass filter setting for front, center and
rear speaker.

! If you carry out auto TA and EQ when a pre-

vious setting of this already exists, the set-
ting will be replaced.

Available accessories

Section

vailable

accessories