Philips VR 708/07 - Manual (Page 9)

E
NGLISH
C
ONNECTING ADDITIONAL DEVICES
9 9
5 Take the enclosed mains cable and connect
the appropriate ends to the mains socket 4 4
on the back of the video recorder and the
other to the nearest free socket
6 Switch on your TV set and select on your TV
set the programme number which will in
future be used for operation with the video
recorder. If necessary, you should refer to the
instructions for your TV set for assistance.
7 Change the settings of this programme
number on your TV set until you see the
adjacent welcome screen clearly and in
colour on the screen
PPRRO OBBLLEEM M
8 You can find more details in the chapter
“Initial Installation”
8 8 TThheerree iiss nnoo tteesstt iim maaggee
4 4 Your video recorder “broadcasts” on the
frequency 583MHz (CH35) in the UHF range (ultra
highfrequency). Repeat the matching of the
selected programme numbers on the TV set.
4 4 Check the cable connections
3 Remove the aerial cable plug from the back of
your TV set and insert it into the aerial
socket 2 2on the back of the video recorder
4 Take the enclosed aerial cable and connect
the appropriate end to the aerial socket of
your TV set and to the TV socket 3 3 on the
back of the video recorder
C Coonnnneeccttiinngg aaddddiittiioonnaall ddeevviicceess
Additional devices, such as a decoder, camcorder, satellite receiver, etc., can be
connected to the scart socket A AVV22 EEX XTT22 on the back of the video recorder.
You will need a scart cable for this (available from specialist stores).
There are two audio output sockets - A AU UX X O OU UTT LL RR - and two input
sockets - A AU UX X IIN N LL RR -on the back of the video recorder . You can
connect a stereo system to these.
AV2 EXT2
AUX IN L
AUX IN R
AUX OUT L
AUX OUT R
CONGRATULATIONS
YOU NOW OWN A NEW
PHILIPS
VIDEORECORDER
TO CONTINUE PRESS OK