Philips LC 6285 - Manual (Page 7)

12. As a safety feature, this projector is equipped with mains lead with a 3-pin grounded plug (for USA-versions only) or a 2-pin
grounded plug (for European versions only).The 3-pin/2- pin grounded plug will fit only into a grounding type mains outlet. If the
plug does not fit, use an adapter that is properly grounded or have an electrician install a grounded type outlet. Do not attempt to
modify this AC plug.
13. For added protection of the projector during a lightning storm, or when it is left unattended or not in use for long periods of time,
unplug it from the wall socket and disconnect any cable systems.This will prevent damage to the projector due to lightning and
power-line surges.
14. Do not overload wall sockets and extension leads with too many products, because this can cause a fire or electric shock.
15. Never push objects of any kind into the projector through cabinet slots as they may touch dangerous voltage points or short cut
parts, which could result in a fire or electric shock.
16. Do not attempt to service the projector yourself other than maintenance issues presented in chapter ‘Maintenance’. Opening or
removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
17. Unplug the projector from the wall socket and refer servicing to qualified service personnel under the following conditions:
A. When the mains lead or plug is damaged or frayed.
B. If liquid has been spilled into the projector.
C. If the projector has been exposed to rain or water.
D. If the projector does not operate normally when you follow the operating instructions. Adjust only those controls that are
covered by the operating instructions; improper adjustment of other controls may cause damage and will often require extensive
work by a qualified technician to restore the projector to normal operation.
E. If the projector has been dropped or the cabinet has been damaged.
F. When the projector exhibits a distinct change in performance - (this indicates a need for service).
18. Upon completion of any service or repairs to the projector, ask the service technician to perform a routine safety check to check
that the projector is in safe operating condition.
19. When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer
that have the same characteristics as the original parts. Unauthorized substitutions may result in fire, electric shock, or other hazards.
20. It is recommended to clean the air filter after every 100 lamp hours.The projector may become too hot if the filter is not cleaned
when required.
21. If the lens becomes dirty or smudged, clean it with a clean, dampened cloth. Never touch the lens with your fingers.
22. Do not look directly into the aperture and lens while operating the projector as this may damage your eyes.
23. Please allow cool down of the projector for a few minutes before switching off the mains.
24. Please dispose of batteries and lamp in special chemical disposal bins.
Philips Home Cinema Projector
7 English User guide LC 6281 / LC 6285
Important Safeguards <
XP LC6281/6285 EVA English 01-08-2003 17:51 Pagina 7