Set up – Philips LC 6285 User Manual
Page 17
6
To switch off the mains supply completely, disconnect the mains lead.
– Save energy! Please put the projector in the Power/Standby position if you are not going to use the
projector for more than 15 minutes.
– If SmartSave is enabled, the projector will switch to StandBy after the selected time.
If SmartSave is not enabled, the projector will not switch to StandBy.
This setting can be changed in the ‘Set up’ menu
– Before disconnecting the mains lead, make sure that the cooling fan has stopped (about 3 minutes
after the projector has been switched to Power/Standby).
•
Use the Zoom ring (LC6285 only) to adjust the size of the image.
•
Use the Focus ring to adjust the focus of the image.
To raise:
•
Keep knob A pressed and lift to raise the projector.
–
The Height/Level Adjuster B will come out.
3
Use the horizontal adjuster C to fine-tune the display angle.
To lower:
•
Keep knob A pressed and gently lower the projector.
•
Use the Focus Ring and Zoom Ring to readjust the focus and size of the image.
3
Use the horizontal adjuster C to fine-tune the display angle.
If projector and screen are not properly placed, the picture will be distorted, producing a
keystoned image (picture top width larger than picture bottom width or vice versa/picture left
side width larger than picture right side width or vice versa). When a keystoned image occurs
the image ratio (4:3, 16:9) will still be guaranteed.This is especially important when the projector
is being used together with an ‘intelligent whiteboard’.
‘Keystone correction’ allows you to correct picture distortion of the vertical and horizontal
(horizontal is only for LC 6285) keystone type by internal scaling.
Vertical keystone correction on LC 6281
•
Use Keystone
to widen the upper part of the image.
•
Use Keystone
to widen the lower part the image.
–
The keystone slider appears on the screen.
•
This correction function also is accessible through the ‘Keystone’ option in the ‘Set up’ menu
of the On Screen Display (OSD) menu.
Adjusting the focus and
size of the image
Adjusting the vertical angle
of the projector
Keystone correction
Philips Home Cinema Projector
17
English User guide LC 6281 / LC 6285
3. Set up
VO
LU
ME +
VO
LU
ME
-
SO
UR
CE
PIC
TU
RE
S
IZ
E -
PIC
TU
RE
S
IZ
E +
MENU
OK
VO
LU
ME
+
VOL
UME
-
SO
UR
CE
PIC
TU
RE
S
IZ
E -
PIC
TU
RE
S
IZ
E +
MENU
OK
STANDB
Y/ON
Focus ring
Zoom ring
STANDBY/ON
A
B
<
STANDBY/ON
C
XP LC6281/6285 EVA English 01-08-2003 17:51 Pagina 17