Pioneer PDP-508XDA - Manual (Page 21)

Watching TV 06
21
En
Note
• You can select “Auto”, “High”, “Mid” or “Low” for the brightness
of the POWER ON indicator. When “Auto” is selected, the
brightness of the indicator changes to “High”, “Mid” or “Low”
to match the brightness level of the viewing area. For details,
see Blue LED Dimmer on page 48.
Changing channels
Use the remote control or the control panel on the right-hand side
of the plasma television to change channels.
• Before operating with the remote control unit, make sure to
select the TV mode using its SELECT button. See Controlling
other equipment using the supplied remote control unit on
page 60.
Switching between the TV and DTV modes
• Press INPUT on the plasma television or TV/DTV on the remote
control unit to select the DTV or TV input mode.
Using P+/P– on the remote control unit
• Press P+ to increase the channel number.
• Press P– to decrease the channel number.
Note
• Press CH RETURN to switch back to the previous channel.
Press CH RETURN again to return to the current channel.
• CHANNEL+/– on the plasma television operates the same as
P+/P–.
• P+/P– cannot pick up analogue channels that are set to skip.
For analogue channel skip, see steps 13 and 14 under Setting
up analogue TV channels manually (page 27).
• While in DTV mode, P+/P– cannot pick up digital channels that
are not registered as favourites, with the Channel Change
function set to “Favourites List”. See Customizing channel
related settings on page 39.
Using 0 to 9 on the remote control unit
• Select channels directly by pressing buttons 0 to 9.
For example:
Press
2 to select channel 2 (one-digit channel).
Press 1 then 2 to select channel 12 (two-digit channel).
While in DTV mode, press 1, 2 then 3 to select channel 123 (three-
digit channel).
Note
• Press CH RETURN to switch back to the previous channel.
Press CH RETURN again to return to the current channel.
• After entering a channel number you can press CH ENTER to
tune in the channel more quickly.
• In standby, when you press 0, the power turns on and images
come from the “INPUT 1” source. Or, when you press any
button from
1 to 9, TV images are displayed.
Changing the volume and sound
Use the remote control or the control panel on the right-hand side
of the plasma television to adjust the volume.
Using i + / i – on the remote control unit
• Press i + to increase the volume.
• Press i – to decrease the volume.
• VOLUME +/– on the plasma television operates the same as
i + / i –.
Using e on the remote control unit
• Press e to mute the sound.
e appears on the screen.
• Press e again or i + to restore the sound.
8
AAA
STEREO
STANDARD
FULL
Channel display
Volume adjustment
Muting