Patton electronic ENVIRONETTM 2100 - Manual (Page 26)

EnviroNET Model 2172 26
EnviroNET User Manual 3 • Configuring the EnviroNET
Switch 7: Ethernet Shutdown
To enable or disable Ethernet Shutdown, push toggle switch seven (7) up or down.
Refer to
table 8 for settings .
Switch 8: Remote Configuration
To enable or disable Remote Configuration, push toggle switch eight (8) up or down.
Refer to
table 9 for settings .
Note The S2-8 switch applies to the remote unit only. If enabled, the
remote unit will follow the dip switch configuration of the local unit.
If disabled, the remote unit will use its own dip switch setting to
determine its Ethernet operating mode and Ethernet Shutdown
mode configuration. The S2-8 switch does not affect the data rate.
The data rate will always follow the local configuration.
Table 8. Ethernet Shutdown
S2-7 Description
ON Ethernet Shutdown Enabled
OFF Ethernet Shutdown Disabled
Table 9. Remote Configuration
S2-8 Description
ON Remote Configuration Enabled
OFF Remote Configuration Disabled