Patton electronic ENVIRONETTM 2100 - Manual (Page 17)

Wiring the power 17
EnviroNET User Manual 2 • Installing the EnviroNET
Wiring the power
Inside the EnviroNET, the power cable is wired to the power supply, but it is not wired externally because dif-
ferent customers require different lengths of power cable for their specific EnviroNET environments. You will
need to provide your desired length of power cable for the unit.
You should run the power cable through the brass gland that is placed to the far left on the bottom panel of the
EnviroNET. (See
figure 5 ). The steps to wiring the power include: running the power cable wires through the
gland, and connecting the power cable wires to the EnviroNET unit.
Running the power cable through the gland
To run the power cable through the gland:
1. Locate the gland that the power cable should be run through. (See figure 5 ).
Figure 5. Gland designated for the power cable
2. You may unscrew the gland to allow more flexibility when threading the power cable wires. To unscrew the
gland, either by hand or with a Crescent® (adjustable) wrench, turn the gland to the left until it is loos-
ened.
3. Carefully thread the wires through the gland from the outside into the EnviroNET.
Note The brass glands on the bottom panel of the EnviroNET can prop-
erly seal cables with an outer diameter between 3mm and 8mm.
Power cable
gland