Patton electronic ENVIRONETTM 2100 - Manual (Page 13)

Before you begin... 13
EnviroNET User Manual 2 • Installing the EnviroNET
Before you begin...
Before you can use the EnviroNET, you must first wire the power cable, wire the terminal block, and configure
the unit.
Note You should complete the wiring and configuration of the EnviroNET
before you mount the unit.
What you will need
The following components are included:
• EnviroNET unit, including PC board, power supply, and interface board
You will need the following components (not included):
• Flat-tip (large-bladed) screwdriver
• Crescent® (adjustable) wrench
• Desired length of power cable
• Desired length of CAT5 (twisted pair) cable
• 4 bolts for mounting (A mounting kit can be purchased seperately).
Opening the case
To open the EnviroNET case ( Figure 2 ):
1. Take a flat tip (large-bladed) screwdriver and insert it into the slot on a lock on the front of the case.
2. Turn the screwdriver counter-clockwise to unlock that lock.
3. Repeat Steps 1-2 for the other lock on the front of the case.
4. Lift the case door gently.
Figure 2. Opening the EnviroNET case
EnviroNET
™
Turn screwdriver
counter-clockwise
to open the case.