Patton electronic ENVIRONETTM 2100 User Manual
Page 21
Configuring the EnviroNET
21
EnviroNET User Manual
2 • Installing the EnviroNET
Configuring the EnviroNET
You should configure the EnviroNET before you mount it.
For information on how to configure the EnviroNET, see Chapter 3,
“Configuring the EnviroNET”
on
page 22.
Mounting the EnviroNET
The EnviroNET can be mounted in two ways: wall mount and pole mount.
Wall mount
The wall mount is the typical way that an EnviroNET can be mounted. You will need four bolts to mount the
EnviroNET.
To mount the EnviroNET:
1. Make sure that the location where you chose to mount the EnviroNET is sturdy and can securely hold the
unit.
2. Be sure that the door to the EnviroNET is securely closed and locked. To lock the case, close the door and
use a flat-tip screwdriver to turn the locks to all the way to the right.
3. Mount the EnviroNET by securing the bolts through the holes on the EnviroNET to the wall panel.
Pole mount
The pole mount option is available by request. For information on how to mount the EnviroNET to a pole,
refer to the EnviroNET Pole Mount Quick Start Guide that shipped with the pole mount kit.