Philips 50PL9126D - Manual (Page 21)

13
Source
This menu allows you to identify the accessory devices you have connected to the
external input/output.
& Select Source in the Setup menu.
é Press the cursor right button to enter the list of types of devices connected to the
selected input.
“ Select the accessory device with the cursor up/down buttons.
When you select AV1 , AV2 , AV3 , HDMI , Side or Analog Audio In , a list appears
allowing you to identify which type of accessory device is attached to this input. The
TV detects the presence of the connected device and the signal is routed accordingly.
Once you have selected the source type, e.g. DVD, this source will automatically be
selected when your remote control is in DVD mode, (see section on Use of the
remote control), and when you press the
AV button on the remote control.
The TV can output Digital audio via the DIGITAL AUDIO OUT(SPDIF OUT)
connector to an external amplifier or receiver.
If your amplifier or receiver has a matching connector for Digital Audio In, you can
connect it with a single cable to the TV’s
DIGITAL AUDIO OUT(SPDIF OUT) .
See section on Digital Surround Receiver.
Clock
This allows you to use your TV as a clock.
- Adjusting the clock is necessary for the correct working of Lock after features.
(See section on TV settings, under Channels menu)
- Closed captioning will not be displayed when the clock is being displayed. Press the clock
button again to switch off the clock if you want to see closed caption.
Auto clock mode
& Select Clock in the Setup menu.
é Press the cursor right button to select the Auto clock mode .
“ Press the cursor right button to instruct the TV to get the time automatically or
manually.
Auto clock channel (only available when Auto clock mode is set to Automatic)
With the cursor buttons, select the channel number where time can be found by the
TV. Typically time can be found on PBS as well as some other channels.
Note: If Manual has been selected in the Auto clock mode, the Auto clock channel menu
item can not be selected.
Time - Day (only available when Auto clock mode is set to Manual)
With the cursor buttons, select and enter the correct time and day.
If
Auto clock mode Manual has been selected, and no clock search has been done,
the system will retain the entered time and day.
Time zone (only available when Auto clock mode is set to Automatic)
This function allows you to select your local time zone. Broadcast time information
will auto correct the clock display for your local time.
& Select Time zone with the cursor down button.
é Press the cursor right button to select your local time zone.
Daylight saving (only available when Auto clock mode is set to Automatic)
Daylight saving time is automatically set by specially broadcast signals. This menu item
allows you to disable the automatic setting of daylight saving time. This is useful if you
live in an area or state where daylight saving is not applied, but you receive channels
from other areas where daylight saving signals are broadcast.
& Select Daylight saving with the cursor down button.
é Press the cursor right button to select Automatic for automatic clock correction
for daylight saving time, based on specially broadcast signals.
“ Select Off to disable automatic clock correction based on the specially broadcast
signals.
Most of the TV channels do not transmit clock
information. There are a few cable channels that do
but they are at the end of the channel ring. There is
no clock transmission in antenna channels. In such
cases, either clock extraction takes a long time, or
there is no clock.
AV 1
AV 2
Clock
Preferences
AV 3
Source
Convergence HDMI
Side
Analog Audio In
Settings
Setup 4 Source 6
Auto clock mide
Auto clock channel
Time
Convergence Day
Time zone
Daylight saving
Source
Clock
Preferences
Settings
Setup 4 Clock 6
DVD
SAT
AV 3 Game
AV 1
HDMI Digital STB
PVR
HD
AV 2
Side
Analog Audio In
Cable
Other
Settings | Setup
Source 6 AV 1 8